Low Voltage Explosion Proof Handlamp w/Inline Transformer

No more looking for the source of low voltage around the jobsite, this model comes with the transformer built-in. Ericson’s Series 1926 handlamp meets OSHA regulations and creates a safer working environment. The Inline Step-Down transformers reduce 120VAC line voltage to 12VAC. Extra-thick walled rubber housing with non-corrosive stainless steel hardware protects the transformer from
jobsite contaminants.

Transformers incorporate a grounded metal shield between primary and secondary windings to ensure the two voltages are isolated providing an added degree of protection. Each transformer is subjected to a factory dielectric test of 1600 volts between primary and secondary windings and between each winding and ground to ensure safety.

High-visibility dual-color safety system for easy identification on the jobsite. A 12 Volt bulb is included (75 W). Note: The transformer housing is not explosion proof.

OSHA 1926.405 (a) (2) (ii) (G): “Portable electric lighting used in wet and/or other conductive locations, as for example, drums, tanks, and vessels, shall be operated at 12 volts or less. However, 120-volt lights may be used if protected by a ground-fault circuit interrupter.”

Specifications:
Lamp Type:	2300/2600 XPI
Secondary Cord Length:	50 Ft.
Primary Voltage:	12 V
Max. Wattage:	100 W
Primary Cord length:	10 ft.
Plug:	NEMA 5-15
Frequency:	60 Hz